100% Canadian

All prices are in CDN dollars.

1-800-585-9331

GPSC PN
Availability
Sale Ends
Notify Me

RIGblaster DXpro Specs

Overall Dimensions (maximum w/o cables) 1.31" H x 9.97" W x 3.87" D
Weight 19.2 oz.
DC Power Requirements USB Powered
PTT Max Contact Rating 2A @ 24V or 1A @ 48V
CW/FSK Direct Keying Ratings Transistor logic only, tube rigs not supported. Postive pull down 20mA max.
Serial Interface Port USB
TTL CAT (dual circuit mini jack connector) Standard/Inverted TTL 5V logic, selectable bi-directional or unidirectional
RS232 CAT (DB9 male) Fully independent, all control signals present including hardware flow control
Sequencer Start Port (Output, RCA female) Transistor logic only. Open collector output, max: 20mA / +40V.
Sequencer End Port (Input, RCA female) Transistor logic only. Internal pull-up to +5V.
The microphone audio is completely isolated from all other grounds. The PTT relay provides adequate current and voltage capability to switch tube rigs.

Quality Declaration

This product has been tested to comply with Part 15 of the FCC rules for a Class B computer peripheral and digital device for use in the home and office. This testing is done to ensure the product does not generate RF interference. The Windows XP, Vista, Windows 7, Windows 8, Windows 10 and Windows 11 PC device drivers for this product have passed Microsoft WHQL testing and are certified. Using certified drivers simplifies the driver installation process and ensures the driver is not going to crash or otherwise damage the PC configuration. The Windows 98 and 2000 drivers are supported. This product is fully enclosed in a metal case and has passed testing at West Mountain Radio to show high immunity to RF interference from amateur radio equipment. This ensures that in a typical station the RF field will not corrupt data transfer. Audio quality testing on this product has shown it to perform excellent with audio signals from 300 to 5000 hz. This demonstrates a low level of distortion for both data and voice. This product has full D.C. isolation on critical circuitry/connections to prevent ground loops and hum pickup. Product designed, tested and used by ham radio operators onsite.

In the Box:

  • RIGblaster DXpro Unit
  • (1) 1/8" Audio Cables, 6 ft.
  • (1) 8-pin Screw-on Custom Mic Cable, 3 ft
  • (1) Powerpole® to 5.5 x 2.1mm DC Plug
  • Instant Setup Connectors
  • USB Cable (A-B)
  • USB Flash Drive with Device Drivers, Owner's Manual & Collection of Ham Radio Sound Card Software
  • Accessory Kit
    • (8) White Jumpers
    • (5) Blue Shunt Jumpers
A USB flash drive of the RIGblaster Software Collection is the standard media. The collection of software programs may be individually downloaded here.